Additive for HPS-3 concrete
- Customer pickup,
- Courier
- In detail
- BrandKG Chemical
- Country of manufactureKazakhstan
Additive for HPS-3 concrete
Hyper plasticizing and a vodoredutsiruyushchayadobavka of the second generation on the basis of the modified polikarboksilatny air for commodity concrete.
Scope
HPS-3 is the plasticizing additive for production of commodity concrete.
Advantages
- allows to receive plastic, udoboukladyvayemy concrete mix, with a sokhranyamost of characteristics in time
- received concrete seven possesses the properties allowing to carry out its transportation on far distances, filling by means of the pump equipment.
- decrease in a water cement ratio In/C to 0,3 at mobility preservation
- decrease in a consumption of cement to 10% in comparison with traditional softeners
Special characteristics
- it is applicable for the designs hardening in the open air
- slows down cement skhvatyvaniye terms for a while of 1,5 o'clock and more.
- when using this additive concrete after filling needs standard leaving in early terms of curing
- when transporting concrete mix on object at loss of mobility of concrete mix (OK) it is necessary to add to the concrete mixer mixer HPS-3 additive mixed with water in a proportion 1/10 (0,5 kg of an additive on 5 l of water) under a condition:
- excess of time of transportation of mix more than 2 hours;
- at a temperature of air from 25 of 0C and above
Technical characteristics
Aggregate state: liquid
Color: yellow-orange
Density at 200C: 1,033±0,02 g/cm3
Maintenance of ions of chlorine: ˂0,01±0,02 g/cm3
Standard: EN 934-2:2009
DOES NOT CONTAIN SALTS OF SULPHATES AND CHLORIDES OF SODIUM (NaSO4, NaCl), CALCIUM (CaCl2, CASO4)
The recommended dosage
0,6-0,8% of the mass of cement
Packing
The additive of HPS-3 is delivered in eurocubes (1000 l).
Storage
To store at a temperature (+ 50C)+ (350C) in the closed capacity. To avoid influence of direct sunshine. At violation of the recommended storage conditions there can be a change of physical and chemical and consumer properties of a product. Observance of the recommended conditions allows to store an additive within 12 months from the date of production. In case of freezing of water solution of an additive after thawing and homogenization the additive can be used according to recommendations.
Precautionary measures
Use of protective gloves during the work with an additive is recommended. At hit of an additive on skin - it is necessary to wash away water with soap. Not to allow hit in eyes. At hit in eyes immediately to wash away a large amount of water, if necessary to see a doctor. To utilize an additive according to rules, not to pour out to the soil, reservoirs, the sewerage.